An FMT engineer replies within one working day. Budget prices from tank size and duty. +91 73852 62875WhatsAppsales@fluidmixtech.comExport buyers

Mixers for adhesives, sealants and resins

Viscous, sticky products whose viscosity rises as the batch is made. They need agitators that keep the whole batch moving, not just the liquid round the impeller.

An adhesive or sealant batch often starts thin and ends very thick. An impeller sized for the start stalls at the end; one sized for the end is wasteful at the start. Viscous products also stick to the vessel wall, where they overheat in a jacketed vessel and spoil the next batch.

For these products we use anchors with scrapers, helical ribbons and multi-shaft mixers that combine slow wall-sweeping agitation with a high speed tool, and size the drive for the torque at the end of the batch.

Typical mixing duties

  • Dissolving polymers and resins
  • Dispersing fillers into viscous bases
  • Blending and heating in jacketed vessels
  • Emulsion polymer production
  • Storage and transfer tanks

What we design for

  • Drive sized for the torque at the highest viscosity
  • Anchor or ribbon with scrapers for wall turnover and heat transfer
  • Separate speed control on each shaft
  • Shaft and seal designed for high torque at low speed

Equipment for adhesives and sealants

Common questions

Anchor or helical ribbon?
An anchor sweeps the wall and is good for heat transfer but does little top-to-bottom mixing. A helical ribbon also lifts the product, so it mixes very viscous batches far better, at a higher cost.
Can one mixer handle the batch from thin to thick?
Yes, if it is designed for both ends of the batch: usually a multi-shaft mixer, or a single agitator on a variable speed drive with enough torque for the end of the batch.

Send us your vessel. We size the agitator.

Tank size, product and what the agitator has to do is enough to start. Send a drawing, a datasheet or just a photo of the tank, and we reply with a recommended design and price, or a budget price first if you need one.

An FMT engineer replies within one working day.