An FMT engineer replies within one working day. Budget prices from tank size and duty. +91 73852 62875WhatsAppsales@fluidmixtech.comExport buyers

Agitator impellers

Impellers supplied on their own, with the hub bored and keyed to fit your existing shaft. Use them to replace a worn impeller, or to upgrade one that does not do the job.

An FMT engineer replies within one working dayBudget price from tank size and duty

Pitched blade impellers with split hubs, in several sizes
Pitched blade impellers with split hubs, in several sizes

The impeller decides what an agitator can do. A slow, wide hydrofoil moves a lot of liquid with little power and is right for blending and keeping solids in suspension. A disc turbine gives shear and gas dispersion. An anchor or helical ribbon is needed once the product is viscous. Choosing the wrong one is the most common reason an agitator under-performs.

We make every type we use on our own agitators. For a replacement we work from your drawing or the old impeller; for an upgrade we check the existing motor, gearbox and shaft first, so that the new impeller does not overload the drive.

Where it is used

  • Hydrofoil: blending and solids suspension at low power
  • Pitched blade turbine: general purpose mixing
  • Disc turbine: gas dispersion and shear
  • Propeller: small tanks and side entry mixers
  • Anchor and helical ribbon: viscous products and heat transfer
  • Saw-tooth disc: high speed dispersion
  • Kicker: mixing at low liquid level

How FMT builds it

HubBored and keyed to your shaft; one piece or split
BladesWelded or bolted, depending on size and service
MaterialsSS 304, SS 316 / 316L or carbon steel
SupplyImpeller alone, or with a new shaft
HydrofoilPitched bladeDisc turbineAnchor
Typical arrangement

The red lines show how the impeller moves the liquid. Every FMT unit is sized for its own vessel, product and duty, so yours is drawn for your tank in the offer.

Send your vessel for a drawing
Looking down into a baffled tank at the agitator shaft and pitched blade impeller
Looking down into a baffled tank at the agitator shaft and pitched blade impeller
Hydrofoil impeller blades and hubs, cut and drilled for assembly
Hydrofoil impeller blades and hubs, cut and drilled for assembly
Stainless steel marine propeller impellers
Stainless steel marine propeller impellers

What we need to size it

  • Shaft diameter at the impeller, keyway size and how the impeller is fixed
  • Drawing or photographs of the existing impeller, with its diameter and blade count
  • Vessel diameter and liquid height
  • Agitator speed, motor rating and gearbox details
  • Product and what the agitator must do
Send what you have. A vessel drawing and a short description of the product and duty is enough to start; we ask for anything else we need. Send an enquiry

Common questions

Can a new impeller improve an existing agitator?
Often, yes. Changing to a better impeller type or diameter can improve blending or solids suspension without changing the drive. We check the motor, gearbox and shaft first so that the new impeller does not overload them.
Do I need to send the old impeller?
No. A drawing, or a few photographs with the main dimensions, is usually enough. We confirm the shaft diameter, keyway and fixing before we make it.

Send us your vessel. We size the agitator.

Tank size, product and what the agitator has to do is enough to start. Send a drawing, a datasheet or just a photo of the tank, and we reply with a recommended design and price, or a budget price first if you need one.

An FMT engineer replies within one working day.