An FMT engineer replies within one working day. Budget prices from tank size and duty. +91 73852 62875WhatsAppsales@fluidmixtech.comExport buyers

Agitators for rare earth and hydrometallurgy plants

Leach, filtrate, precipitation and solvent extraction feed tanks: chloride and acid liquors, often carrying solids, that have to keep moving reliably around the clock.

Rare-earth and other hydrometallurgy plants take metals into solution and then separate and recover them: leaching, filtration, solvent extraction, precipitation and washing. Most of these steps run in agitated tanks, and the liquors are usually chloride or acid solutions that decide the materials as much as the mixing does.

We size each agitator for its tank and duty. Liquor and filtrate tanks need turnover at low power, which suits high-efficiency hydrofoils; tanks with settling solids get a kicker impeller near the bottom; long shafts in tall tanks get a steady bearing. Wetted parts are SS316L as standard for these liquors, with Hastelloy on request where the analysis calls for it. Send the liquor analysis, temperature and tank drawing, and the offer states the material we propose for you to confirm.

For ore slurries, leach trains and thickener duties, see agitators for mining and mineral processing.

Reference job

5 KL filtrate tank agitator for a rare-earth processing plant, Visakhapatnam (2024)

DutyKeeps a sodium chloride filtrate solution (SG about 1.2, water-thin, ambient) circulating in a 5 KL tank
TankØ1650 × 2500 mm straight side, supplied by the client; agitator designed to its drawing
ImpellersTwo AF-2 high-efficiency hydrofoils, Ø850 mm, and a Ø500 mm kicker near the bottom
Drive1.5 kW 4-pole IE3 motor with a parallel helical gearbox, about 86 rpm
ShaftØ60 mm, about 2.7 m long, with a steady bearing and a rigid removable coupling
MaterialsWetted parts SS316L, drive frame painted MS
ChecksUltrasonic-tested shaft bar, balancing report, material certificates and a quality dossier with the dispatch

Typical mixing duties

  • Filtrate and liquor holding tanks
  • Leach and dissolution tanks
  • Precipitation and pH adjustment tanks
  • Solvent extraction feed and wash liquor tanks
  • Reagent make-up: acids, alkalis and flocculants

What we design for

  • High-efficiency hydrofoils for turnover at low power
  • Kicker impeller near the bottom where solids settle
  • Steady bearing and removable coupling on long shafts
  • SS316L wetted parts; Hastelloy on request
  • Ultrasonic-tested shaft material, balanced impellers and a quality dossier

Equipment for rare earths and hydrometallurgy

Common questions

Which impeller suits a filtrate or liquor tank?
Usually high-efficiency hydrofoils, which turn the tank over at low power and low shear. On our Visakhapatnam job two AF-2 hydrofoils and a smaller kicker near the bottom keep a 5 KL sodium chloride filtrate tank moving with a 1.5 kW drive.
What material should the wetted parts be?
SS316L suits most chloride liquors at ambient temperature. Hotter or more acidic liquors may need a higher alloy such as Hastelloy. Send the liquor analysis and temperature; the offer states the material we propose, for you to confirm.
Can you supply an agitator for an existing tank?
Yes. We design the agitator to your tank drawing, nozzles and roof, as on the Visakhapatnam job, where the client supplied the tank.

Send us your vessel. We size the agitator.

Tank size, product and what the agitator has to do is enough to start. Send a drawing, a datasheet or just a photo of the tank, and we reply with a recommended design and price, or a budget price first if you need one.

An FMT engineer replies within one working day.