An FMT engineer replies within one working day. Budget prices from tank size and duty. +91 73852 62875WhatsAppsales@fluidmixtech.comExport buyers

Assessment of existing mixers

When an agitator does not mix well enough, wears out seals or bearings, vibrates or overloads its motor, we find out why and recommend the change that fixes it.

View inside a polished agitated tank showing the shaft and impeller
View inside a polished agitated tank showing the shaft and impeller

Most agitator problems come down to a handful of causes: the wrong impeller type or diameter for the duty, a speed chosen for another product, a shaft running too close to its critical speed, too much deflection at the seal, or a drive that was undersized from the start. Batch sizes and products also change over the years while the agitator stays the same.

We review the drawings and operating data, inspect the agitator on site where needed, and check the design against the present duty. The result is a written recommendation, which may be as simple as a new impeller or speed, or a retrofit of the shaft, bearings, seal or drive.

What it includes

  • Review of drawings, process data and operating history
  • Site inspection of the agitator and vessel where needed
  • Check of the impeller, speed and power against the present duty
  • Mechanical check of shaft, bearings, seal and mounting
  • Written recommendation with the options and their cost

When to use it

  • Solids settle, layers form or batches are not uniform
  • Mixing or batch time is too long
  • Mechanical seals or bearings fail early
  • The agitator vibrates or the shaft runs out
  • The motor overloads or trips
  • The product, batch size or vessel level has changed

Common questions

Can an existing agitator be improved without replacing it?
Often it can. A new impeller, a speed change through a gearbox or variable speed drive, a steady bearing or a better seal can solve the problem at a fraction of the cost of a new agitator.
Do you assess agitators made by other manufacturers?
Yes. We assess any make and recommend the most economical fix, which may be a modification rather than a replacement.

Send us your vessel. We size the agitator.

Tank size, product and what the agitator has to do is enough to start. Send a drawing, a datasheet or just a photo of the tank, and we reply with a recommended design and price, or a budget price first if you need one.

An FMT engineer replies within one working day.