An FMT engineer replies within one working day. Budget prices from tank size and duty. +91 73852 62875WhatsAppsales@fluidmixtech.comExport buyers

Rotor-stator high shear mixers

A rotor turning at high speed inside a close-fitting stator. Product is drawn into the head and forced out through the stator openings at high velocity, which breaks droplets and particles down quickly.

An FMT engineer replies within one working dayBudget price from tank size and duty

Rotor-stator mixing head: slotted stator around a four-blade rotor
Rotor-stator mixing head: slotted stator around a four-blade rotor

Rotor-stator mixers give far more shear than an open impeller or disperser disc, concentrated in a small zone. They are used to make emulsions, to homogenise, to disperse fine powders and to dissolve gums and polymers that would otherwise form lumps.

The stator opening pattern sets the balance between flow and shear: larger openings for more flow and coarse work, finer ones for emulsions. Because the head treats only what passes through it, the mixer must be able to turn the whole batch over; in larger or more viscous batches we add a slow agitator, or recommend a bottom entry or multi-shaft arrangement.

Where it is used

  • Emulsions and creams
  • Homogenising and particle size reduction
  • Dissolving gums, polymers and thickeners
  • Fine powder dispersion

How FMT builds it

DriveDirect drive motor, variable speed drive on request
HeadRotor-stator with interchangeable stator openings
MountingTop mounted on a vessel, bridge or lift
Wetted partsSS 316 / 316L
Typical arrangement

The red lines show how the impeller moves the liquid. Every FMT unit is sized for its own vessel, product and duty, so yours is drawn for your tank in the offer.

Send your vessel for a drawing
Two bottom entry high shear mixers with rotor-stator heads, before fitting
Two bottom entry high shear mixers with rotor-stator heads, before fitting
Jacketed creamer tank with agitator and bottom outlet
Jacketed creamer tank with agitator and bottom outlet

What we need to size it

  • Vessel diameter, straight-side height and bottom shape (dished, conical, flat)
  • Working volume and liquid level range, including the lowest level at which mixing must continue
  • Product: density, viscosity at operating temperature, solids content and particle size
  • What the agitator must do: blend, suspend, disperse, dissolve, heat or cool, react
  • Operating and design pressure and temperature, and whether the vessel is open or closed
  • Preferred materials, seal type, motor make, power supply and hazardous-area classification
Send what you have. A vessel drawing and a short description of the product and duty is enough to start; we ask for anything else we need. Send an enquiry

Common questions

Rotor-stator or high speed disperser?
A rotor-stator gives finer droplets and particles and is the choice for emulsions and fine dispersions. A disperser handles higher viscosity and larger powder additions and costs less. Many plants use both, in sequence or on a multi-shaft mixer.
Can a rotor-stator mixer handle a viscous batch?
Only up to a point: as viscosity rises, the head stops turning the batch over. Above that, add a slow anchor or move to a bottom entry high shear or multi-shaft arrangement. We will tell you which applies to your product.

Send us your vessel. We size the agitator.

Tank size, product and what the agitator has to do is enough to start. Send a drawing, a datasheet or just a photo of the tank, and we reply with a recommended design and price, or a budget price first if you need one.

An FMT engineer replies within one working day.