What a blend tank agitator has to do
A blending tank agitator has one main job: to make the whole batch uniform in a reasonable time, every time. Depending on the product it may also have to keep solids in suspension, wet and disperse powders, dissolve solids, or move heat to and from a jacket. And it has to keep doing this while the tank is being filled and emptied, not only when it is full.
The right agitator depends on the product, so the first step is to sort the products the tank will make into the groups below and size for the hardest of them.
Thin liquid blends
Most solvent-based blends, water-based solutions and light oils are thin. For these, the agitator needs to turn the whole tank over, top to bottom, without wasting power on shear. A hydrofoil or pitched blade impeller on a top entry agitator does this well. Baffles on the tank wall stop the liquid simply swirling round with the impeller and forming a vortex, which mixes poorly and can draw air into the product.
Viscous blends
As viscosity rises, an impeller moves only the liquid close to it, and the rest of the tank stays still. Viscous products need larger impellers turning more slowly, with more torque from the drive. At high viscosity, close-clearance impellers such as anchors or helical ribbons are needed to move the product near the wall. Where a viscous product also has to be dispersed, a multi-shaft mixer combines a slow anchor with a high speed tool.
Products that take powders
Powders tend to float on the surface or form lumps that dissolve slowly. A high speed disperser pulls powder down into the liquid and breaks up agglomerates; a rotor-stator mixer gives finer dispersion and is used for gums and thickeners that must be fully hydrated. Adding the powder slowly into a well-mixed liquid, at the right point in the recipe, matters as much as the mixer.
Liquids that do not want to mix
Components with very different densities or viscosities, or liquids that are not fully miscible, separate again if the mixing is too gentle. A heavy component can sit on the bottom, and a light one can float. These products need an agitator that circulates the whole tank strongly; where a stable emulsion is the aim, they need high shear.
Mixing at low level
Blend tanks are rarely full. Charging starts with a small amount of liquid, and emptying ends with a heel at the bottom. If the agitator must keep mixing at these levels, the bottom impeller has to sit low, close to the bottom head, and a small kicker impeller near the bottom may be added. Running an impeller near or above the liquid surface causes vibration and splashing, so the lowest level at which the agitator runs should be set in the design.
Heating and cooling
Some blends need heat to dissolve waxy or viscous components, or cooling to hold a temperature. A jacket on the shell and bottom does the heat transfer, and the agitator has to keep the product moving past the wall. In viscous products an anchor with scrapers keeps a fresh layer at the wall and improves heat transfer.
Seals and drives for solvent service
Open tanks for non-hazardous products can run with a simple seal. Closed tanks with flammable or toxic solvents need a mechanical seal to keep vapour in, and a double mechanical seal where no leakage to atmosphere is acceptable. In a hazardous area the motor must suit the area classification; flameproof motors are the usual answer, and air-motor drives are used where electric motors are not allowed.
Size for the hardest product
A multi-product blend tank is only as good as its agitator on the most difficult product. Size the impellers, speed and drive for that product, then check the others: a thin product in a tank sized for a viscous one may need a lower speed, which a variable speed drive provides. Send us your product list and tank details and we will recommend the agitator, or see top entry agitators and chemical blending plants.